Want to buy exhaust assembly parts? Order now

When to replace exhaust assembly?

Over time, the exhaust assembly parts can wear, crack or corrode. For example, the seals can leak, the rubbers can dry out or the holders can break off due to rust. In most cases, these defects are unavoidable. The exhaust is located at the bottom of the car where a lot of stone chips, dirt and moisture can reach the exhaust parts. This can eventually cause the parts to wear out faster. In addition, the exhaust will rust faster if only short distances are driven. Condensation forms in the exhaust. The exhaust gets very hot on longer rides, so that the moisture can be evaporated. Do you only drive short distances by car? Then the exhaust cannot always get hot enough to evaporate the condensation and rust and damage will therefore occur.

When an attachment part such as a spring, seal, holder or other attachment part breaks, it is important to replace it. Liquids and gas can leak, the exhaust can hang loose or there can be a lot of noise. In addition, the car will be rejected during the MOT and you can receive high fines with a defective exhaust.

Exhaust repair

With exhaust assembly parts you can restore the exhaust. The Winparts range includes rubbers, clamps, holders, sealing rings, pipe connections and screws, bolts & nuts. In addition to the individual parts, you can also contact us for a complete assembly kit or exhaust paste for a good seal. Are you going to work with the exhaust? Then make sure that the car is safely placed on the bridge or on car jacks with the support of axle stands. When you are going to work under the car, it is important that it is safe and stable.

Buy exhaust assembly

You can easily and quickly buy exhaust attachments or exhaust assembly parts from Winparts. Not sure which parts are suitable for your vehicle? Simply enter the car model and the correct assembly parts will be displayed. Are you looking for other parts for the exhaust system? At Winparts you will also find particle filters, valves, performance exhausts and DIY exhausts.

Exhaust clamp

The exhaust attachment is an important part of the exhaust. The assembly parts ensure that the exhaust is properly secured and remains in place. The exhaust assembly can crack or break over time and must be replaced. Winparts has a complete range for mounting the exhaust. In our range you will find, among other things: clamps, rubbers, seals, assembly kits and springs. Want to know which parts you need for your car? Then do the car model check quickly and easily!

6421 - 6440 / 6503 products

Filter

0 filters selected

Block view
List view

Screw, exhaust system

Article Type: Screws, bolts and nuts
Alternatively
Thread Measurement 2: M10x1.25x28
Guarantee: 2 years
Strength class: 10.9
DIN standards (Screws): DIN 835 (stud)