Discover Quality Bump Stops at Winparts Today

Bump stop worn

The bump stop can become worn. This happens when, for example, you often drive on an uneven road surface or when you go too fast over high speed bumps. A worn bump stop can be recognized by cracks, deformation or loss of elasticity. In addition, a worn rubber can cause oil leakage from the strut. Check the rubbers regularly for defects so that further wear on the car parts can be prevented. We also recommend that you replace the CV bootss and the bump stop when replacing the shock absorbers. In most cases, the complete suspension strut will have to be disassembled when you want to replace the bump stop. By replacing all parts of the suspension system at the same time, you save yourself a lot of effort. In addition, these parts often wear proportionally. In many cases, the CV boots and bump stop are worn even earlier, because they provide the first protection to the suspension system.

Replacing bump stop

Bump stops cannot be repaired and must therefore always be replaced in case of wear or damage. To replace the bump stop, the system of the shock absorber or strut must first be disassembled. Then remove the old CV boots and bump stop. Then clean the shock absorbers well and install the components to be replaced. You can now reassemble the whole thing. It is recommended to replace both sides per axle. The parts usually wear proportionally per axle.

Buy bump stop

You can easily find the right bump stop with your car model. You can easily enter these on our website, the suitable car parts will then be displayed. Are you looking for other car parts for the suspension system? At Winparts you will also find coilover kits, lowering kits, anti-roll bars, air suspension and auxiliary springs.

Bump stops

The bump stop of the car protects the suspension system from damage. This rubber ensures that the suspension cannot spring too far in the event of a major impact, thus preventing damage or premature wear to the shock absorbers. This suspension is the damping of the car and absorbs the blows caused by, for example, an uneven road surface. The bump stop is mounted on all four shock absorbers of the car, both on the front and rear axle. Check the bump stops regularly for wear or damage and replace them if necessary. At Winparts you will easily find the right bump stops with your car model. You can easily enter these on the website, the correct car parts will then be displayed.

161 - 180 / 5210 products

Filter

0 filters selected

Block view
List view

Rubber Buffer, suspension 36979 FEBI

5 1 review

Rubber Buffer, suspension 36979 FEBI

5 1 review

Fitting Position: Rear Axle
Pieces needed: 2
Number in packaging: 1
Application: Rubber stoppers
Material: PUR
Outer diameter [mm]: 60
Guarantee: 3 years
Length [mm]: 85